HIKARI MULTI-HEAD PRODUCT INTRODUCTION

6.TAP HOLE CHECK UNIT

Contents:
Many of examination with screw go by manual labor.
This is the machine which was developed to do the inspection reasonably.
This contributes to shortening of the examination with screw time, labor saving, quality improvement.
This is most suitable for the inspection of the screw diameter (M1.6~ M6).
This has a lot of results of the auto mobile parts, electronic parts
Drive source:
The drive source of this is a small motor (10W - 40W).
(connected with a flexible wire.)
This can use even a drill press.

HMT-P110 (TYPE-A) HMT-P110 (TYPE-A)
applied set applied set


Guidance

The other products carry it by the example introduction of the Japanese site,
and please look at it.

Details are here.(Japanese)

Pagetop